For instance: You have a single side sensor ES 3.0 and you want to get into the stationary traffic supervision? Then we are the right partner! Use your mobile single side sensor ES3.0 for the stationary unit too. Take the benefits of our optical technology:
- ES3.0 mobile can be operated at nearly all locations
- Optical sensor, no road works necessary
- 3 lanes can be documented with only one digital camera unit FE3.0 ST
- Both traffic directions can be monitored at the same time
- Fully automatic measurement with digital camera
- Lanes can be documented with only one digital camera unit FE3.0 ST
- Optimal images, very good driver and license plate recognition
- No half-yearly maintenance required by law
- Device can be completely relocated
- Non-ambiguous assignment through lane selection and speed independent photo point
- Turn-off lanes and bus lanes can be excluded
- All measurement data and photos are secured by a public key. Therefore, only unmodified pictures and measurement files can be evaluated
- Evaluation of the data can be performed at any place
A novelty, both traffic directions can be monitored at the same time
Another innovation of this stationary technology is the feature that you can evidentially monitor both the incoming and the running off traffic at the same time with only one additional digital camera unit FE3.0 ST and one (resp. two) displaced flash unit BE1.1 ST (without another measuring unit).
The relocation of the measuring devices to the other location are easy and user friendly.
Description of operation
Measuring principle
The measurement principle of ES3.0 is based on measuring distance and time. The velocity (v) of a vehicle results from the measurement base (s) and the time (t) in which the vehicle passes through the measurement base. When driving through the measurement base, in each of the five sensors a brightness profile is captured, digitalized and stored. The brightness profiles of the three parallel oriented sensors are used for determining the temporal offset which is used for calculating the speed.
Because of the optical measuring principle compared to the loop measuring principle the eso company provides a wear less solution. With the single side sensor ES3.0 it is possible to monitor up to 3 lanes or both directions of travelling at the same time.
The basic configuration of ES3.0 consists of a sensor head on a tripod, a computer unit with measurement expansion card, a touch-screen monitor, a digital camera unit FE3.0 and corresponding accessories. To increase the illumination of the photo area, especially during darkness, a flash unit BE1.1 is used.
The ES3.0 can be plied with an additional photo device (if necessary, with another flash unit). In this configuration, speed measurements with frontal photo documentation for driver identification can be performed either in both traffic directions or for several lanes simultaneously.
The single side sensor ES3.0 ST can be located beside the road or in the middle of a motorway (between the lanes)
The measurement values equaling or exceeding the pre-set speed threshold are saved in the computer and can be transferred to another system using a storage device (USB2.0 memory stick).
The single-side sensor is suited for any traffic setup, e.g. in areas with reduced speed limits, on curvy roads, on highways with 4 lanes, on motorways etc.
Motorcyclists can be documented as proof by triggering front and rear camera simultaneously.
The stationary eso speed enforcement unit ES3.0 ST consists of following components:
- One digital camera unit FE3.0 for monitoring and evidential photography documentation of one traffic direction on up to three lanes
- One measurement unit ES3.0 with computer unit RE3.0 and monitor (touch screen)
- One flash unit BE1.1 ST
- Two eso security posts (protected against vandalism)